MSDS Sheet for Mer*Tap 317
Go To JJ Merlin Homepage
∑ Health: 0 ∑ Fire: 1 ∑ Reactivity: 0 ∑
SECTION 1- MATERIAL IDENTIFICATION
Material / Trade Name:Mer*Tap 317 Emergency Telephone:330-666-8609
SECTION 2- INGREDIENT
Specific information is considered as a trade secret and is withheld per CEF 1910:1200 (h). Medical personnel requiring this information should contact J.J. Merlin Systems with their request per CER 1010:1200 (h).
SECTION 3- PHYSICAL DATA
Boiling Point: 409.0 F @ 15 mmHg Physical Form: homogeneous solution & flake
Specific Gravity: .815-.848@ 77.0 F Solubility in H2 O, % by Volume: Insoluble
Vapor Pressure: n/a Evaporation Rate: > 1.0
Vapor Density: 1.000 @ AIR=1 Percent Volatiles: no data
Color and Odor: clear, L color 5Y O.5R Max pH: 6-7
Liquid Density: 7.060 lbs./gal @ 77.0 F
SECTION 4- FIRE AND EXPLOSION DATA
Flash Point (Method Used): 200o F PMCC By Product of Combustion: May form carbon dioxide
Flammability Limits: n/a and carbon monoxide
Extinguishing Media: Dry Chemical, foam, water spray (fog).
Unusual Fire Explosion Hazards: None
SECTION 5- REACTIVITY DATAStability Hazardous Polymerization
__X__ Stable ____ Unstable ____ May Occur __X__ Will Not Occur
Conditions and Materials to Avoid: Strong oxidizing agents.
Hazardous Decomposition Products: May form carbon dioxide and carbon monoxide
SECTION 6- OCCUPATIONAL EXPOSURE LIMITS
No exposure limits have been set for this product. As with all industrial materials, exposure of this product to the skin and eyes should be avoided.
SECTION 7- HEALTH INFORMATION
Eye irritation: non-irritating.
Skin irritation: FHSA Rating: not a primary skin irritant; Index 1.3
Oral toxicity: Single dose oral toxicity is low. Swallowing large amounts may be harmful.
SECTION 8- EMERGENCY AND FIRST AID PROCEDURES
Eyes: Flush with large amounts of water, lifting upper and lower lids occasionally.
Skin: Wash exposed areas of the body with soap and water.
Inhalation: Remove from area of exposure, seek medical attention if symptoms persist.
Ingestion: If swallowed seek medical attention. If individual is conscience and alert, induce vomiting. Do
not leave individual unattended.
SECTION 9- EMPLOYEE PROTECTION
Respiratory Protection: Not required under normal conditions of use.
Protective Clothing: Safety glasses, goggles or face shield recommended to protect eyes from mists or splashing. Neoprene or rubber gloves recommended to prevent skin contact.
Other protective Measures: Employees must practice good personal hygiene, washing exposed areas of the skin and laundering contaminated clothing.
SECTION 10- ENVIRONMENTAL PROTECTION
Spill Clean-Up Procedures: Remove sources of ignition, contain spill to smallest area possible. Stop leak if possible. Pick up small spills with absorbent materials such as paper towels, "Oil Dry", sand or dirt. Recover large spills for salvage or disposal. Wash hard surfaces with safety solvent or detergent to remove remaining oil film. Follow local, state and federal disposal regulations.
SECTION 11- SPECIAL PRECAUTIONS
Store in closed containers below 120o F.
Keep away from oxidizing agents, excessive heat and ignition sources.
Store and use in well-ventilated areas.
Do not store or use near heat, sparks, or flame; store out of sun.
Do not puncture, drag or slide this container.
Drum is not a pressure vessel.
SECTION 12- TRANSPORTATION REQUIREMENTS
DOT Classification: Class 65 DOT Info.- 49 CFR 172.101: Not regulated by DOT
NOS Component: none RQ (Reportable Quantity)- 49 CFR 172.101: n/a
SECTION 13- REGULATORY INFORMATION
SARA 302 Components- 40 CFR 355 Appendix A: none California Proposition 65: none
SARA 313 Components- 40 CFR 372.65: none CERCLA RQ-40 CFR 302.4: none
SECTION 14- DATE
Date of Preparation: November 1, 1995
Date of Correction: December 2, 2007
Reason for change: Confirmation of updated information.
This information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any other process. Such information is to the best of the companyís knowledge and believed to be accurate and reliable as of the date indicated. However, no representation, warranty or guarantee of any kind, express or implied, is made as to its accuracy, reliability or completeness and we assume no responsibility for any loss, damage or expense, direct or consequential, arising out of use. It is the userís responsibility to satisfy himself as to the suitableness and completeness of such information for his own particular use.